| Author |
Topic: question about stereo effects hookup |
Ben Godard
From:
Jamesville NC
|
Posted 24 Mar 2009 12:47 pm |
|
I have a MB studio preamp, Lexicon MPX1, and Stewart 1,2 power amp. I have the MPX1 going through the effects send and return of the mesa boogie.
The problem is that I always have a more wet sound and slightly louder sound on the right speaker versus the left speaker it a little quieter and more dry .
Should I just do away with the effects loop and just go direct (out one unit and into the next). how do the proffessionals use this setup.
Thanks
Ben |
|
|
 |
Steve English
From:
Baja, Arizona
|
Posted 24 Mar 2009 1:38 pm
|
|
I would first make sure that the reverb program(s) your are using contain NO dry signal in the returns, all wet on both left and right returns.
Is your effects send mono or stereo on the MB?
_________________
Always remember you're unique..... Just like everyone else |
|
|
|
Buddy Castleberry
From:
HAWKINSVILLE GA USA - R.I.P.
|
Posted 24 Mar 2009 2:31 pm
|
|
BEN FIRST YOU TO GO INTO THE SYSTEM AND MAKE
SURE ITS SETUP FOR STEREO. THEN LIKE THE POST ABOVE YOU I WOULD USE THE MAIN OUTPUTS AND NOT USE THE EFFECTS LOOP. DID I PUT MY PROGRAMS IN YOUR MPXI
IF SO YOU CANT USE THE LOOP |
|
|
|
Ben Godard
From:
Jamesville NC
|
Posted 24 Mar 2009 7:00 pm
|
|
| Buddy, I don't have your presets yet. We spoke about it in an email but I just haven't got around to it yet. I've been using user preset #118. It sounds vey good but not the same from both speakers. |
|
|
|
