| Author |
Topic: Amplifier setting for Peavey 400 Chorus |
Tommy Gibbons
|
Posted 3 Jan 2009 2:29 pm |
|
| I am a steel beginner (8 months), I don't know how to set the amp to get a good clean steel sound. Maybe the amp is not the one I should be using. I just don't know. Your input and advice will be greatly appreciated! Thanks, Tommy. |
|
|
 |
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 5 Jan 2009 7:43 pm Stereo Chorus 400
|
|
Hey Tommy,
I've never tried out the SC for steel guitar as it was designed for six string guitar reproduction. However, this is not to say that you cannot obtain the tonality that you are looking for.
Just make sure that you set the post gain at a higher setting than the pre gain control on the channel of your choice. The rest of the control settings are subjective. If you will call me at the factory with your amp and guitar set up for "experimenting", I'll be glad to walk you through the various controls. I can be reached toll free at 1-877-732-8391, ext. 1180 Monday through Friday from 8am to 5pm CST.
Mike Brown
Peavey USA |
|
|
|
Tommy Gibbons
|
Posted 5 Jan 2009 8:40 pm Amp Setting
|
|
Thanks Mike, I will be in touch!!!
Tommy Gibbons |
|
|
|
Donny Hinson
From:
Glen Burnie, Md. U.S.A.
|
Posted 5 Jan 2009 8:50 pm
|
|
| The amp is fine for a beginner, or even some pros. Use the same settings that are used for the NV 400. |
|
|
|
Tommy Gibbons
|
Posted 5 Jan 2009 8:53 pm Peavey Chrous 400
|
|
Thanks Donnie,
That's what I needed to hear...$$$
Tommy |
|
|
|
