| Author |
Topic: need Emmons endplate |
Steven Black
From:
Gahanna, Ohio, USA
|
Posted 27 Aug 2008 8:30 am |
|
| I need an Emmons all pull endplate not the one with the square openings but the other end where it is all solid, the endplate that is to the right of the guitar, does anyone have one of these? Steveb. |
|
|
 |
Ron !
|
Posted 27 Aug 2008 11:43 am
|
|
I know that Ron Lashley sells these in his on-line shop.Maybe that'll help.
Ron |
|
|
|
Steven Black
From:
Gahanna, Ohio, USA
|
Posted 30 Aug 2008 6:32 am Emmons Endplates
|
|
| Hello Ron thanks for the info, I read your post about a little boy needing parts to build a pedal steel guitar, I have a MSA single 12 that Jim Flynn set up for my girl friend, she read your story and was ready to send the MSA to you, but I told her that this guitar maybe to complicated for a young lad like him, a single 10 with three pedals and 5 knee levers will keep him busy for a long time, good luck and keep me informed on your new project for the boy, post pictures. |
|
|
|
Ron !
|
Posted 30 Aug 2008 7:01 am
|
|
Just check with Ron Lashley Steven.It might look expensive but this is probably the way to go for you.I have never seen a set of LeGrande plates on the forum yet.But who knows....you might be lucky in your quest.I sure hope you are my friend.
Ron
P.S
I send you a PM |
|
|
|
