| Author |
Topic: test ....Pod HD Desktop Leg Rack design |
Craig Schwartz
From:
McHenry IL
|
Posted 10 Jun 2012 6:13 pm |
|
The only reason I`m creating this rack is to get it off the floor, I`ve watched accidentals happen with it, I watched bass players bump it, singers pull the chords out and not know they did anything, The wires spider out at every angle and I`m trying to tame it abit
Stage before welding
made it possible to fit sierra square legs and round normal legs.... The angle of rear legs appear to be 8-9 degrees on two different PSG`s (Sierra and Wilcox)....I chose right rear leg only, because I`m Right handed and did not want a bar accident to happen, also keeps the front of the guitar good looking and no clutter
You pod owners will want to make one of these, It will also fit on a mic stand (just in case your anal about your PSG leg)
I will add more photos when finished, Show and tell using Steel forum ethics
_________________
SO MANY LURES, SO LITTLE TIME.... |
|
|
 |
Craig Schwartz
From:
McHenry IL
|
Posted 17 Jun 2012 9:21 am Pod Rack finished
|
|
Welded and rubber coated , thumb screws have a thin spring plate under rubber coating , so it will tighten to leg without harming it. solid as it gets,
now I can get back to playing and not be haunted by another professional 
There you have it, If I could have purchased one of these for $100 bucks, I would have gladly purchased one, (believe it or not it was alot of designing to get it right)
best regards
Craig
_________________
SO MANY LURES, SO LITTLE TIME.... |
|
|
|
Richard Sinkler
From:
aka: Rusty Strings -- Missoula, Montana
|
Posted 17 Jun 2012 10:36 am
|
|
That's pretty cool. This is the wrong section to post that in. No one will see it here (except the insanely curious like me). You should contact Bob to move this into either PEDAL STEEL or ELECTRONICS where it will be seen.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 54 years and still counting. |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 17 Jun 2012 1:33 pm
|
|
| There is already a leg bracket for the POD XT/X3/HD that is made/sold by Tommy Dodd. |
|
|
|
Lee Baucum
From:
McAllen, Texas (Extreme South) The Final Frontier
|
Posted 17 Jun 2012 2:29 pm
|
|
That looks like a really sturdy unit.
Here is a link to Tommy Dodd's site:
Click Here |
|
|
|
Craig Schwartz
From:
McHenry IL
|
Posted 17 Jun 2012 8:16 pm
|
|
I have a PM into BOB
Thanks Guys,
FYI: This rack is very strong, I wrestled the idea from an electricians Pipe bender
_________________
SO MANY LURES, SO LITTLE TIME.... |
|
|
|
