| Author |
Topic: Parts Identification Request (MSA?) |
Bryan Bradfield
From:
Lethbridge, Alberta, Canada.
|
Posted 14 May 2008 4:48 pm |
|
What make is the pedal, and where can I get replacements?
What make is that threaded ball joint, and where can I get replacements? The threaded portion of the stud is 10-32. |
|
|
 |
Daniel J. Cormier
From:
Lake Charles, LA, USA
|
Posted 14 May 2008 5:02 pm MSA for sure
|
|
The pedal in the picture is an MSA pedal. I might have one or two around my shop. Should be able to get the ball connector from George L.
_________________
Daniel J. Cormier
Rittenberry with Tone to the bone,profex or tubefex and what ever amp, hilton pedal, BJS bars. Email at kajunsteelman@yahoo.com.
Last edited by Daniel J. Cormier on 14 May 2008 5:04 pm; edited 1 time in total |
|
|
|
Bill Moore
From:
Manchester, Michigan
|
Posted 14 May 2008 5:04 pm
|
|
Looks like an MSA pedal, The ball joint is a standard part, you can probably get one from Linkon steel guitars, in Canada. Probably can get new pedals there too. One thing, if you have had a problem with breaking off the stud when it's screwed into the upper hole on the pedal, there is a set crew already in that hole which makes the depth a little shallow for the stud. if there is any gap when it's screwed in, it will break off. Either grind a little off the end of it, or put some washers there.
_________________
Bill Moore...
my steel guitar web page
 |
|
|
|
Bryan Bradfield
From:
Lethbridge, Alberta, Canada.
|
Posted 17 May 2008 6:56 am
|
|
| Thanks Daniel & Bill. I've been in contact with Joan Link at Linkon Steel Guitars, and it looks like they can accommodate my needs. |
|
|
|
