| Author |
Topic: Fender vibrasonic |
Bennie Hensley
From:
Yakima, Washington, USA
|
Posted 9 Feb 2007 8:05 am |
|
| Fender amp won't come on at all. Red indicator light won't even come on. Fuse is ok..any suggestions? |
|
|
 |
Ken Fox
From:
Nashville GA USA
|
Posted 9 Feb 2007 9:48 am
|
|
Bad power cord or connection inside chassis (at fuse holder, etc)
bad fuse holder
The transformer secondary gives 6.3 VAC to the tube filaments and the tube heaters. If no tube heaters are glowing and no power light I would suspect the bulb is OK and that the transformer is not getting primary power (120VAC) from the line cord. |
|
|
|
Bennie Hensley
From:
Yakima, Washington, USA
|
Posted 9 Feb 2007 3:38 pm That fixed it !
|
|
| Ken thanks for the advice. There was a broken wire at the power plug cord. Put a new end on it and it works fine...thanks again...... |
|
|
|
Jim Palenscar
From:
Oceanside, Calif, USA
|
Posted 10 Feb 2007 7:30 pm
|
|
Whew!  |
|
|
|
Bennie Hensley
From:
Yakima, Washington, USA
|
Posted 11 Feb 2007 6:15 am
|
|
| Whew is right Jim, I got lucky for once. |
|
|
|
