| Author |
Topic: Zane Beck pull rod question |
Norris Ashment
From:
Idaho Falls Idaho, USA
|
Posted 30 Jun 2007 8:20 am |
|
I have a real nice ZB S10 that I'm changing to a Emmons set but I need to modifiy or build some pull rods but we can't find a DIE that will fit either the coarse or fine thred ends. 1 apears to a #40 and the coarse seems to be a #32. A 6-40 and a 8-32 Dies or to small. What did they use for Rods and DIES ?
Serial # 0678. Any help sure would be appreciated
Norris |
|
|
 |
Kevin Hatton
From:
Buffalo, N.Y.
|
Posted 30 Jun 2007 8:36 am
|
|
| Norris, they are 640 dies, left and right hand threads on the turnbuckles. Eighth inch rods work. I have spokes, fret bords, and some other parts if you need them. |
|
|
|
Norris Ashment
From:
Idaho Falls Idaho, USA
|
Posted 30 Jun 2007 10:31 am Thanks Kevin
|
|
| I was going to try some 1/8 rod today to make some new ones. I still need to find a 6 40 left hand Die which I can't seem to find |
|
|
|
Chick Donner
From:
North Ridgeville, OH USA
|
Posted 30 Jun 2007 10:40 am
|
|
| The original rods, at least on my '67 sn 0013, are 5/32 rods, with the threads mentioned above. Makes a #6 die work, though. |
|
|
|
Norris Ashment
From:
Idaho Falls Idaho, USA
|
Posted 30 Jun 2007 3:03 pm
|
|
| Thanks Chick. I think thats what these are. |
|
|
|
