Ken Fox
From:
Nashville GA USA
|
Posted 9 Jun 2004 3:04 pm |
|
Excellent with manual. Has balanced inputs and outputs and +4db selectable (for PA use) and standard output for instrument use. I am selling off my PA equipment, as I do not use it anymore. $250.00 shipped to the lower 48. I can do PayPal
Here are the specs:
Audio Frequency Response: 20Hz - 20kHz (+1, -2dB); Dynamic Range: 96dB typical, greater than 90dB; Noise Level: Less than -72dB (IHF-A Filter); THD: Less than 0.03% (1kHz @max. level, CD 20kHz LPF filter)
AD/DA Conversion AD: 20-bit, 64-times oversampling; DA: 20-bit 8-times oversampling; Sampling Rate: 44.1 kHz
MIDI Control Program Change, Control Change, Parameter Change, Bulk Dump
Memories Preset: HALL 1-25, ROOM 1-25, PLATE 1-25, SPECIAL 1-25; User: HALL 1-25, ROOM 1-25, PLATE 1-25, SPECIAL 1-25
Inputs Connector: XLR-3-31 type x 2, phone jack x 2; Nominal Level: +4/-10dB switchable; Impedance: 20 kOhms
Outputs Connector: XLR-3-32 type x 2, phone jack x 2; Nominal Level: +4/-10 dB switchable; Impedance: 150 Ohms
Front Panel Controls: INPUT LEVEL, PRE DELAY, REV TIME, HI-RATIO, ER LEVEL; Buttons: TYPE, PRESET/USER, -, +, STORE, AUDITION, EFF LEVEL, UTILITY; LCD: Custom LCD; LED: Two four-segment level meters, UTILITY, EFF LEVEL; Switches: POWER
Rear Panel Connectors: INPUT L/R (XLR x 2, phone jack x 2), OUTPUT L/R (XLR x 2, phonejack x 2), FOOT SWITCH (phone jack), MIDI IN, MIDI OUT,(5-pin DIN x 2); Switches: INPUT LEVEL (+4/-10 Db), OUTPUT LEVEL (+4/-10 Db)
Power Requirements 120 V, 60 Hz, 15 W
Dimensions (W x D x H) 480 x 227.9 x 45 mm (18.9" x 9" x 1.8")
Weight 3.5 kg (7.7 lb.)
[This message was edited by Ken Fox on 09 June 2004 at 06:22 PM.] |
|
