Height setting for Bill Lawrence 7-10 pickup

Larry Burdette · From: Williamstown, WV, USA

Hi

I am putting a Bill Lawrence 7-10 pick up on my Emmons Legrande 2,Could anyone tell me how high I should set the pick up from the strings? thanks. reach me at songwriter@charter.net

Tony Dingus · From: Kingsport, Tennessee, USA

I was told to the thickness of 3 quarters stacked. The first time I used one I had it too close to the strings. BIG MISTAKE!! This pick up has some power, I called Bobbe Seymour and he told me the height to start with. Hope this will help.
Tony

Vernon Hester · From: Cayce,SC USA, R.I.P.

use three quarters as a gauge works great.
(3/16ths of an inch)

Vern

Ann Fabian · From: Mesquite, Texas, USA

More ideas for replacing pickups are here as well: http://www.steelguitarinfo.com/other/pickups/pickups.html on http://www.SteelGuitarINFO.com which is essentially an OnLine Owner's Manual for most all brands of steel guitars.

Hope that helps

Ann Fabian
Carter Steel Guitars
www.SteelGuitar.com
www.SteelGuitarINFO.com
www.OnLineSteelers.com
www.CarterStarter.com

Earnest Bovine · From: Los Angeles CA USA

Larry
Why don't you just experiment, and put it where it sounds good to you?

J Hollenberg · From: Vlaardingen, The Netherlands

I also installed a BL 710-97 on my Lashley LeGrande.
First: install it without the nylon spacers underneath.
The distance between the pickup and the strings is on my guitar 5 millimeters.
It sounds great.

Greetings from The Netherlands.
Jack Hollenberg
steelguitar@planet.nl

------------------

[This message was edited by J Hollenberg on 15 March 2003 at 09:52 AM.]

John Bechtel · From: Nashville, Tennessee, R.I.P.

According to Paul Sr., Vernon is correct. (3/16") It works fine on my Franklin guitar! "Big John" http://community.webtv.net/KeoniNui/BigJohnBechtels

Forum Index > Steel Players		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: