| Author |
Topic: dual amp connect - howto? |
Terry Srader
From:
Georgia
|
Posted 26 Apr 2004 10:09 am |
|
what is the best way to connect dual amps.
is it best to plug both amps into my GR pedal or to plug each amp into each other and only one cable to the GR?
|
|
|
 |
b0b
From:
Cloverdale, CA, USA
|
Posted 26 Apr 2004 10:30 am
|
|
| Moved to 'Electronics' section. |
|
|
|
Ron Randall
From:
Dallas, Texas, USA
|
Posted 26 Apr 2004 8:23 pm
|
|
The easiest way is to come out of the volume pedal, using the 2 outs. Go straight to each amp. The technical name for this setup is dual mono. I use it myself. One amp on each side.
Hope this helps!
Ron
|
|
|
|
Gary Goodman
From:
Covina, California, USA
|
Posted 26 Apr 2004 10:57 pm
|
|
I run 2 cables from my volume pedal 1 to each amp. if you volume pedal doesn't have 2 outs on it radio Shack has an adapter that
plugs in to your 1 output and gives you two outputs I used that before I had a pedal with 2 outs and it worked good.
Gary
------------------
Sho-Bud LDG, Evans Fet 500, Nashvill 400, Hilton volume pedal |
|
|
|
David L. Donald
From:
Koh Samui Island, Thailand
|
Posted 27 Apr 2004 1:19 am
|
|
| Ideally also you should have both amps plugged to the same multi plug buss bar to prevent ground loops. |
|
|
|
Craig A Davidson
From:
Wisconsin Rapids, Wisconsin USA
|
Posted 27 Apr 2004 1:55 am
|
|
| If you get ground buzz in your hook-up, try a ground lift plug on one amp. Make sure you do plug both of them in on the same circut. |
|
|
|
John Bechtel
From:
Nashville, Tennessee, R.I.P.
|
Posted 27 Apr 2004 9:08 pm
|
|
It's a good idea to use a Ground-lift plug on the A/C strip at the wall-socket also, and don't Cross X A/C cords either. It's quietist with only (2)-wires all the way around on all components! Just my opinion, from past experience! 
------------------
“Big John” Bechtel
Franklin PSG D–10 (9 & 
Fender ’49–’50 T–8 Custom
Fender ’65 Reissue Twin-Reverb Custom™ 15
click here
click here |
|
|
|
