Which type of volume pedal is suitable for 3 wir

Buck Nosaka · From: Atsugi,Kanagawa,JAPAN

Very sorry for I did not explain clearly.
When I hook up my PS to the amplifire using 3 cable hook up system by Peavey.
My question is which type of Volume pedal is suitable , 500K type or 10K type ?

Roger Crawford · From: Griffin, GA USA

Buck...everyone that I know that uses the three wire hook up uses the standard 500 ohm pot that comes in all pot pedals.

Mike Brown · From: Meridian, Mississippi USA

Yes, that is the most common.

Larry Bell · From: Englewood, Florida

And, Buck, if you are using the 10K pots in the Goodrich H10K or L10K pedals, you should be aware that the 3-cable hookup may not be of any benefit, since those pedals have a buffer amp built into them which solves the same problem -- loss of highs when you use the pedal to lower the volume.

Just a thought worth mentioning.

------------------
Larry Bell - email: larry@larrybell.org - gigs - Home Page
2003 Fessenden S/D-12 8x8, 1969 Emmons S-12 6x6, 1971 Dobro, Standel and Peavey Amps

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: