Profex II delay ?

David Coplin · From: Eugene, Oregon, USA

I have recently bought a used profex II and I am waiting for it to be delivered.I have never used one and I am wondering if it has
a delay mode in it. Also, where can I pick
up the settings for steel (ie. Newman settings ? Thanks
David Coplin

Ken Fox · From: Nashville GA USA

If you are ever up in the Portland area, I will be glad to load the Newman settings for you and give you a run through on using the Profex 2. It has a nice delay built in. Just email me if I can help out.

basilh · From: United Kingdom

How much is a nearly new one worth ?
Baz
www.waikiki-islanders.com

------------------

Ken Fox · From: Nashville GA USA

I would think $250.00 to $275.00 range. As of late, they have been bidding a lot higher on Ebay. Last year they were much lower, I think they are being re-discovered!

[This message was edited by Ken Fox on 31 March 2003 at 04:41 PM.]

Mike Brown · From: Meridian, Mississippi USA

As always, Ken is of great help and a good person to place your trust in. I will also be glad to assist you with your Peavey product and can be contacted at 1-877-732-8391, toll free from 8am-5pm CST weekdays. Thanks for using Peavey products.

Mike Brown
Peavey Electronics Corporation

Pete Burak · From: Portland, OR USA

"...where can I pick up the settings for steel (ie. Newman settings ?..."

Here ya go!
http://web.tampabay.rr.com/jstoner1/ttlist.htm

basilh · From: United Kingdom

I got one for about 100 bucks :- http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&category=22669&item=2518942757

and a nice steel to go with it. http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=2517281260

Where can I get a midi dump of the "Steel" settings ?
Baz www.waikiki-islanders.com

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: