One of the two OUTPUTS on the right side of the rear panel can be used as a direct out if you are not using a stereo effect in the chain of effects. However, if you are operating the Profex II in a stereo setup(both LEFT and RIGHT outputs simultaneously), you can program FX into the Profex II preset chain and use the LEFT/MONO output in the effects loop output jacks, to send a direct signal to the mixing console. Of course, the parameters of that FX function would have to be setup for sufficient signal output.
If you have a question concerning this setup, feel free to give me a toll free call in the U.S. at 1-877-732-8391 and I'll be glad to assist you.
Mike Brown
Peavey Electronics Corporation [This message was edited by Mike Brown on 31 March 2003 at 08:37 AM.]
