| Author |
Topic: Flextone to Nashville 400? |
Dave Birkett
From:
Oxnard, CA, USA
|
Posted 17 Sep 2002 11:50 pm |
|
| I've got a Line 6 Flextone II Plus that I use for guitar. If I ran my steel into it, is there a way to use its modelings and effects and then run the signal into a Nashville 400? Thanks. |
|
|
 |
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 18 Sep 2002 5:23 am
|
|
I checked the info that is available on the Line 6 website and it doesn't explain what input and outputs are available on this model, so you would be in a better position to tell us. However, if the Line 6 has a preamp out, you could connect this output to the power amp input of the N'Ville 400 to use the power amp and speaker of the 400. If you patch from the L6 preamp out to the low gain input on the 400, this may be satifactory. However, you will probably notice an increase in the noise level because you would then be using two preamps.
Mike Brown
Peavey Electronics Corporation |
|
|
|
Dave Birkett
From:
Oxnard, CA, USA
|
Posted 18 Sep 2002 10:33 am
|
|
| Mike, thanks. Peavey is truly the best in customer service. |
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 18 Sep 2002 1:21 pm
|
|
| You are welcome. |
|
|
|
