| Author |
Topic: Nash 400 out to board |
JBM
From:
Pittsgrove, NJ USA
|
Posted 14 Jun 2001 5:40 pm |
|
Where should I run a line out of my Nashville 400 to go into our PA mixing board? Should I go through a DI box?
------------------
joe merlino
www.homecookinbluegrass.com
|
|
|
 |
Craig Allen
From:
BEREA, KENTUCKY, USA
|
Posted 14 Jun 2001 7:03 pm
|
|
From the "Power Amp Out."
A D.I. is best, but not needed.
Bon Chance |
|
|
|
Bob Knight
From:
Bowling Green KY
|
Posted 14 Jun 2001 7:59 pm
|
|
You are almost right. 
Preamp OUT to board is correct and will work great.
The power amp jack on a N'ville is IN |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 15 Jun 2001 2:23 am
|
|
I run mine through a D.I. box. Preamp out to D.I. box to board. Actually the Nashville 400 is better miked, but if you don't want to use a mike use the D.I. box, that way you can use the 600 ohm balanced line.
I keep my D.I. box "permanently" mounted in my Nashville. I used a large piece of velcro and have it mounted on the inside just down from the preamp out jack. When I need it, it's right there. |
|
|
|
JBM
From:
Pittsgrove, NJ USA
|
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 15 Jun 2001 5:24 am
|
|
We've offered a product through our accessory program for at least 25 years that called an EDI(electronic direct interface). This device is connected at the speaker output of the amp. Take a look at it here; http://www.peavey.com/media/pdf/accessories/power.pdf
If you have any questions about it, please feel free to contact me here at Peavey at 1-877-732-8391. |
|
|
|
