| Author |
Topic: cross shafts |
ebb
From:
nj
|
Posted 24 Apr 2024 10:02 am |
|
not more than 8 inches long and also supported bell cranks if available
thanks
ed |
|
|
 |
Wayne Brown
From:
Bassano, Alberta, Canada
|
Posted 25 Apr 2024 2:57 am steel guitar parts
|
|
Hi Ed
You are a little unclear in your original post. Not really enough information to go on. Exactly what cross shafts are you looking for. Emmon's , fessenden, carter, homemade. I would need to know more to try and help you out a little better.
Thanks
Wayne
_________________
Owner Out West Music,Seats,Parts and accessories
www.outwestcountry.ca |
|
|
|
ebb
From:
nj
|
Posted 25 Apr 2024 9:17 am
|
|
my only requirement is that the length of the cross shaft with the mounting block does not exceed 8 inches. since i am going to use the parts on a fender it does not matter the configuration (square, round etc) since i will be retrofitting.
the availability of bell cranks that would work with the configuration would be a plus. what i can't buy i will have to fabricate |
|
|
|
Wayne Brown
From:
Bassano, Alberta, Canada
|
Posted 25 Apr 2024 11:14 am steel guitar parts
|
|
Thank you for the clarification.
Thanks
wayne
_________________
Owner Out West Music,Seats,Parts and accessories
www.outwestcountry.ca |
|
|
|
