Another BL-705 wiring question

John Jeansonne · From: Texas, United States

I have searched the forum, but the explanations vary so I thought I’d post again. I am replacing the stock single coil pickup in my Mullen Discovery with a BL-705. The pickup is wired directly to the output jack. There is no switch. Can someone explain the wiring of BL-705 directly to the output jack?

I have seen some posts that say:

1. Red wire to output jack tip
2. Twist green and white wires together and connect to nothing. Just insulate the connection.
3. Black and bare wires to output jack ground

Is this correct? Or should it be done a different way?

Thanks!

Dave Meis · From: Olympic Peninsula, Washington, USA

That will give you the full humbucker. 👍

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: