Nashville 400 volume pot

Alan Cook · From: Kent,England

My Nashville 400 volume pot breaks up in the lower section. It's the push pull pot. Anyone know where I could get a new replacement pot!
Alan.

Mike Auman · From: North Texas, USA

See this thread: https://bb.steelguitarforum.com/viewtopic.php?t=147961
_________________
Long-time guitar player, now wrestling with lap steel.

Raybob Bowman · From: S. Lake Tahoe, CA, USA

tubesandmore.com
_________________
Sierra U12 4+5 / 1933 Dobro / homemade Tele B-bender

Alan Cook · From: Kent,England

Thanks, has anyone fitted one is it difficult?

Raybob Bowman · From: S. Lake Tahoe, CA, USA

I have a hard time with PCB pots. I replaced the presence pot on my Session 400 but used a regular size Alpha pot with wires soldered to the board where the old pot was.
_________________
Sierra U12 4+5 / 1933 Dobro / homemade Tele B-bender

Bill A. Moore · From: Silver City, New Mexico, USA

replacing isn't hard, but my experience is having to gain access.
The "snap in" pots have the bracket as well as the connections soldered to the board. I use a "solder sucker" to remove as much of the solder as possible, also the bracket "snaps" into the board. Gently pry between the pot bracket and the board while applying heat to the bracket connections.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: