| Author |
Topic: Emmons Pickup Height Adjusting Screws |
Benjamin Franz
From:
Melbourne, Victoria, Australia
|
Posted 9 Jan 2023 8:02 pm |
|
Can anyone tell me the size/thread for the pickup height adjusting screws on this 1971 Push Pull? Two of them rattled loose in the case and were lost on stage as the guitar was removed from the case. Thanks in advance.
 |
|
|
 |
Kelcey ONeil
From:
Sevierville, TN
|
Posted 10 Jan 2023 2:23 am
|
|
They are 6-32 thread size, and 3/4 of an inch long.
There should also be a piece of spring about 3/8 long between the neck and pickup plate.
_________________
Co-owner and operator: Emmons Guitar Co. |
|
|
|
Benjamin Franz
From:
Melbourne, Victoria, Australia
|
Posted 10 Jan 2023 6:39 am
|
|
| Thank you Kelcey. Much appreciated. I was aware of the springs. |
|
|
|
George Duncan Sypert
From:
Colo Spgs, Co, USA
|
Posted 15 Jan 2023 4:00 pm Pickup height
|
|
| What would the proper distance between bottom of the strings and top of the poles on the pickup? |
|
|
|
Richard Vogt
From:
Iowa, USA
|
Posted 31 Jan 2023 9:24 am Pick-up plate for PPT
|
|
Any one have a pick-up plate that they would like to sell or know where I could buy one for Emmons PP.Thank you Richard Vogt. e-mail dgerry2@msn.com or call me at
515)7788682 |
|
|
|
Ron Funk
From:
Ballwin, Missouri
|
Posted 31 Jan 2023 5:24 pm
|
|
George asked -
"What would the proper distance between bottom of the strings and top of the poles on the pickup?"
The old rule of thumb was the thickness of a US quarter.
Hope that helps -
Ron |
|
|
|
Richard Vogt
From:
Iowa, USA
|
Posted 5 Feb 2023 10:28 am Pick up plate
|
|
| Found one. |
|
|
|
