| Author |
Topic: Sho-Bud Christmas Tree Amp Questions |
Nicholas Wagoner
From:
New York, USA
|
Posted 26 Apr 2021 6:09 am |
|
Hey everyone, im new to the site and glad to be here. I picked up a Sho Bud pro-1 and just got a Sho Bud Christmas Tree amp to go along with it.
It's been modded from the factory with an added mid control on each channel, and a "longer" and "deeper" reverb. There's also a switch marked "amp" or "phones" and I can't figure out what that does. I have the factory schematics with the mods drawn in on it, which i can provide if needed
Id love to get some help learning more about this amazing amp
 |
|
|
 |
J Fletcher
From:
London,Ont,Canada
|
Posted 26 Apr 2021 7:09 am
|
|
Hi Nicholas
Nice sounding amps those Sho~Buds . The preamp is pretty much a transitor version of a typical Fender preamp , and the output section is taken from the RCA Transitor Manual , minus the protection circuit as I recall . Came supplied with a JBL D 130F speaker . About 60 watts RMS .
I had one a few years back , though it was a real warm , good sounding amp . Heavy though .
Jerry |
|
|
|
Steve Hinson
From:
Hendersonville Tn USA
|
Posted 28 Apr 2021 3:08 pm
|
|
Nicholas,
Would it be possible for you to post those schematics?
TIA
SH |
|
|
|
Kenneth Kotsay
From:
Davie/Ft Lauderdale, Florida
|
Posted 3 May 2021 8:31 am
|
|
On Saturday I played through one with my D-10 Franklin at a buddy's home, very nice sounding amp,
I also left a note for Santa, Christmas wish list. |
|
|
|
Dave Meis
From:
Olympic Peninsula, Washington, USA
|
Posted 3 May 2021 4:08 pm
|
|
| Probably just turns off the speaker? Do the headphones work in the 'amp' mode? |
|
|
|
