| Author |
Topic: Paul Franklin pedal |
Jory Simmons
From:
Elkhorn, Wisconsin, USA
|
Posted 24 Jan 2021 9:01 am |
|
Hey Guys..What Notation do you use for the Paul Franklin pedal?
One guy told me he calls it pedal D… (It is pedal 4 on his guitar) and tabs that I write I have been calling it PF… But that’s just me is there an industry standard for notating this change?
_________________
Jory Simmons
Last edited by Jory Simmons on 24 Jan 2021 10:08 am; edited 1 time in total |
|
|
 |
Jeff Garden
From:
Center Sandwich, New Hampshire, USA
|
Posted 24 Jan 2021 9:23 am
|
|
| Hey Jory, why don't you become the new industry standard with "PF"? Might want to put a note on your tab that says what it stands for. I haven't seen any other tab using it yet and since some guys have it in position 0 and others in position 4, the letters make sense. Seems E9 has always used letters for pedals with A, B, C and C6 has always used numbered pedals so that makes further sense to use letters for an E9 pedal. |
|
|
|
Jory Simmons
From:
Elkhorn, Wisconsin, USA
|
Posted 24 Jan 2021 9:44 am Franklin Change
|
|
I actually do put a * By the "PF" then notate it on the bottom of the page. I think PF is good because some guys put it on a knee lever. I have a new customer that has gotten 4 tabs in two week from Me....He just took delivery on a New Mullen G2 U12. He's a Beginner too! He emailed me and asked about the franklin Pedal....I asked Him why he ordered it to begin with..He said 'cause a buddy of his told Him it was "Cool". I told Him just take a Video lesson with Me...
_________________
Jory Simmons |
|
|
|
William Carter
From:
Cedar Rapids, Iowa, USA
|
Posted 27 Jan 2021 9:56 am
|
|
If somebody put FP I would figure out what it meant.
_________________
_________________
ZumSteel D10, Mullen G2 SD12 Universal, Rittenberry SD10 |
|
|
|
