| Visit Our Catalog at SteelGuitarShopper.com |

Post new topic Bill Lawrence 705 wiring questions
Reply to topic
Author Topic:  Bill Lawrence 705 wiring questions
Paul Sutherland

 

From:
Placerville, California
Post  Posted 14 Jul 2020 11:14 pm    
Reply with quote

I'm trying to get a Lawrence 705 wired and seem to be stuck. My pickup is the newer series with 4 colored wires plus the shield. I've read prior posts and been trying every combination imaginable.

I know both banks of the 705 work because I get a little over 10k reading on my meter when I connect to the Green and Black leads, or the Red and White leads. I want to use the pickup in full humbucker mode reading about 20k on the meter. There is no coil tap switch to worry about.

I know that you have to connect the two banks to get full humbucker performance. Most sources say to tie off/solder and insulate with either tape or heat shrink the green and white leads. I've done that repeatedly and always get a reading of zero. I know my meter is working. I've tried every other combination of wires for this connection of the two banks, and get either zero or 10k, depending on the combo used.

Can anyone shed any light on this? Is it possible that there is a short in the pickup that is preventing the two banks from connecting, even though each bank works independently? I know my soldering skills are not top notch, but I can usually get the job done.
_________________
It don't mean a thing if it ain't got that swing.
View user's profile Send private message Send e-mail
Ian Worley


From:
Sacramento, CA
Post  Posted 15 Jul 2020 12:51 am    
Reply with quote

Hi Paul, try tying the red and green for humbucking. White is hot, black is ground. This worked correctly for me, measures 20.6k Ohms. Also, be sure when you're checking it that your ohmmeter range is set high enough, 200k ohms or higher. It will register as open if set to 20k and the total series resistance of both coils exceeds that.

View user's profile Send private message Send e-mail
Paul Sutherland

 

From:
Placerville, California
Post  Posted 15 Jul 2020 3:28 am    
Reply with quote

Success!! I use the same meter and I had been setting it to 20k. When I switched to 200k I got a steady reading of 20.9/21.0. So the pickup is good. Thanks Ian.
_________________
It don't mean a thing if it ain't got that swing.
View user's profile Send private message Send e-mail

All times are GMT - 8 Hours
Jump to:  
Please review our Forum Rules and Policies
Our Online Catalog
Strings, CDs, instruction, and steel guitar accessories
www.SteelGuitarShopper.com

The Steel Guitar Forum
148 S. Cloverdale Blvd.
Cloverdale, CA 95425 USA

Click Here to Send a Donation

Email SteelGuitarForum@gmail.com for technical support.


BIAB Styles
Ray Price Shuffles for Band-in-a-Box
by Jim Baron