| Author |
Topic: Sold on another website. |
Justin Myers
From:
North Carolina, USA
|
Posted 17 Mar 2020 8:41 am |
|
Sold on reverb.com
_________________
Justin Dale Myers
jmyerspedalsteel@gmail.com
Last edited by Justin Myers on 19 Jun 2020 4:07 pm; edited 2 times in total |
|
|
 |
Andy Taub
From:
New York, USA
|
Posted 18 Mar 2020 11:12 am Hi
|
|
| What's the knob on the back? Would you say this is like a princeton reverb in volume/sound? |
|
|
|
gary pierce
From:
Rossville TN
|
|
|
|
Justin Myers
From:
North Carolina, USA
|
|
|
|
Justin Myers
From:
North Carolina, USA
|
|
|
|
Sonny Jenkins
From:
Texas Masonic Retirement Center,,,Arlington Tx
|
Posted 5 May 2020 2:33 pm
|
|
| What does that unit weigh? |
|
|
|
Frank Canino
From:
Illinois, USA
|
Posted 7 May 2020 6:14 am
|
|
| PM sent. |
|
|
|
Jon Jaffe
From:
Austin, Texas
|
Posted 7 May 2020 5:47 pm
|
|
Sonny,
Head 16-1/2" W x 8" H x 7-1/2" D 12lbs |
|
|
|
Justin Myers
From:
North Carolina, USA
|
|
|
|
George Frachiseur
From:
Arkansas, USA
|
Posted 19 May 2020 5:23 am Milkman
|
|
| PM Sent |
|
|
|
Rich Gibson
From:
Pittsburgh Pa.
|
Posted 29 May 2020 4:20 am
|
|
Hi Justin I can’t quite make out the back of the amp
Is there 2 speaker outs?
Both 8 ohms?
Is the max power at 4 ohms?
300 watts at 4 ohms
150 at 8ohms
The manual doesn’t specify
Thanks |
|
|
|
Bill Hatcher
From:
Atlanta Ga. USA
|
Posted 29 May 2020 9:44 am Re: Hi
|
|
| Andy Taub wrote: |
| What's the knob on the back? Would you say this is like a princeton reverb in volume/sound? |
the knob is the output control for the line/preamp out. looks like it is 1/4" and an xlr for balanced.
in regards to this being like a princeton....this is a tube preamp section with a solid state power output section. it would not be anything like a princeton in regards to volume. from the info on the amp, it looks like the preamp section is driving the tubes at high voltage. this will be a totally different sound than most other hybrid tube pre/solid state power amps. most of those run off reduced voltage in the tube pre section so they wont have to have two separate power supplies or a circuit to achieve that.
looks like you can use the preamp section separate from the amp section for a stand alone preamp if needed. |
|
|
|
Justin Myers
From:
North Carolina, USA
|
|
|
|
