| Author |
Topic: Adjusting a Hilton Volume Pedal |
Bud Harger
From:
Belton, Texas by way of Baton Rouge, Louisiana
|
Posted 7 Feb 2020 4:09 pm |
|
My Hilton volume pedal lets too much volume out at the “off†position. I want to decrease that volume level at the “off†position, but still allow “some†volume there.
Which way do I turn the “OFF POSITION†dial to do that? I don’t want to screw this up!
Thanks.
_________________
bUd
1969 Emmons D-10 8f/4k; Evans Amps; Benado Steel Dream. |
|
|
 |
Ian Rae
From:
Redditch, England
|
Posted 7 Feb 2020 4:39 pm
|
|
I can't remember. Mark the current position with tape and a pen so you can find it again*, then trial and error.
You can't break anything.
* second thoughts, if you don't like it how it is you wont care about finding it again. So that leaves T&E.
_________________
Make sleeping dogs tell the truth!
Homebuilt keyless U12 7x5, Excel keyless U12 8x8, Williams keyless U12 7x8, Telonics rack and 15" cabs |
|
|
|
Eric Dahlhoff
From:
Point Arena, California
|
Posted 7 Feb 2020 5:17 pm
|
|
Do turn the adjustment pot GENTLY. I adjusted mine to have a bit of signal when "off". Very easy. It helps to have a steady signal playing through it (tone generator, CD whatever) then just hold it in the "off" position and turn the pot.
_________________
"To live outside the law you must be honest." (Bob Dylan) |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 8 Feb 2020 3:21 am
|
|
As noted be very careful as those pots are fragile and easy to break.
I thought newer Volume pedals do not have holes for those adjustments as users kept damaging the pots. |
|
|
|
David Nugent
From:
Gum Spring, Va.
|
Posted 8 Feb 2020 8:27 am
|
|
| Bud..P.M. sent regarding pedal problem. |
|
|
|
Damir Besic
From:
Nashville,TN.
|
|
|
|
