| Author |
Topic: Should this Moyo volume pedal be killing my high end? |
Joseph Myers
From:
North Carolina, USA
|
Posted 1 Sep 2019 2:59 pm |
|
Perhaps this is just how it is. I can't say it sounds bad as I like a softer high end but compared to the steel direct into the amp, the high end is severely cut. Is this normal for the Moyo pedal. I'm using a George L 10-1
joe |
|
|
 |
Joseph Myers
From:
North Carolina, USA
|
Posted 1 Sep 2019 3:42 pm
|
|
Close this one up...I have found the problem. Crappy cable from pedal to steel.
When I swapped out pickup to the 10-1 I just used an old cable as I was in a hurry to test it. An old 70's curly cable. Forgot to change it out. Wow, did that kill tone.
All's well...
joe |
|
|
|
Ian Worley
From:
Sacramento, CA
|
Posted 1 Sep 2019 3:58 pm
|
|
| It's normal behavior for a passive pot volume pedal to kill some high frequencies, though maybe not as much as your old curly cable! You can overcome this with an active buffer in the signal chain ahead of the VP to lower the high impedance of the pickup's output signal. A Sarno Freeloader, Black Box, Lil Izzy, etc. This will help overcome the potential signal loss from long cable runs too. That said, some players actually prefer the effect of rolling off the highs as the volume pedal is backed off. |
|
|
|
Joseph Myers
From:
North Carolina, USA
|
Posted 1 Sep 2019 4:12 pm
|
|
| Yep, I prefer the volume pedal back off a bit. And I usually use nice cables. Kind of got in a rush when I got the 10-1 in and forgot about it. |
|
|
|
Glenn Taylor
From:
Denver, CO, USA
|
|
|
|
