| Author |
Topic: Roland Cube 80 |
James Taylor
From:
United Kingdom
|
Posted 22 Aug 2019 2:36 am |
|
Hi,
I wonder if anyone can help with this situation? I have a Roland Cube 80 amp and it has been working fine. However, for some unknown reason the tone has changed and I have tried altering the controls without success; in fact it sounds toneless to me. Has anyone any ideas what the answer would be???
James Taylor |
|
|
 |
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 22 Aug 2019 4:53 pm
|
|
James, if you could post a clear picture of the controls I'd like to have a look at the settings.
_________________
Too much junk to list... always getting more. |
|
|
|
Dick Wood
From:
Springtown Texas, USA
|
Posted 28 Aug 2019 6:10 am
|
|
Try changing cables. I had an issue once where I wasn't getting any volume. I tried another cable and that cured it.
_________________
Cops aren't paid much so I steel at night. |
|
|
|
Peter Harris
From:
South Australia, Australia
|
|
|
|
James Taylor
From:
United Kingdom
|
Posted 3 Sep 2019 8:15 am
|
|
Hi Stephen,
Thank you, I fixed it by holding down the control switches with the on switch on off position and then with both switches on hold I switched on the power and that has reset it excellently.
This advice I got on another post on this form.
Thank you all on this particular post BLESS YOU ALL
JAMES |
|
|
|
