| Author |
Topic: volume pedal looping |
John Walls
From:
Effingham, Illinois, USA
|
Posted 25 Jan 2006 4:42 pm |
|
| Is it ok to run cable from psg to transtubefex then to amp input,then with another set of cables run vol.pedal through the loop in and out without damage to equipment? thanks in advance John |
|
|
 |
Gordy Hall
From:
Fairfax, CA.
|
Posted 25 Jan 2006 5:16 pm
|
|
Have you tried it? A clever idea, and I can't see how it could cause any damage if it works.
That is a VERY interesting use of the loop section on the amp.
Gordy
|
|
|
|
John Walls
From:
Effingham, Illinois, USA
|
Posted 25 Jan 2006 6:15 pm
|
|
Gordy
It probably would work, maybe Mike Brown will see this and chime in. My rig is MSA, TTfex, Hilton ped. and NV400. Later. |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 26 Jan 2006 3:14 am
|
|
As long as you keep the output level of the TT Fex low you should be OK. The TT Fex is designed to be used as the preamp and effects processor and to drive a power amp with "line level". "line level" would cause severe overloading on the amp input.
You might want to consider using the low gain input on the amp rather than the "normal" input. That will help in minimizing overloading in case you get the output level of the TT Fex too high. |
|
|
|
John Walls
From:
Effingham, Illinois, USA
|
Posted 26 Jan 2006 3:32 pm
|
|
| Thanks Jack, Preamps are new to me so it's best to ask questions. thanks again, John. |
|
|
|
