| Author |
Topic: Pull rod size |
Jimmy Gibson
From:
Cornwall, England
|
Posted 24 Mar 2019 3:12 am |
|
Could someone please give me the size of the pull rods on a Emmons LeGrande 2 ?.
Cheers,Jim. |
|
|
 |
Jerry Overstreet
From:
Louisville Ky
|
Posted 24 Mar 2019 5:32 am
|
|
| I defer to J. Roller et al, but as far as I know they are 7/64 or .109. |
|
|
|
Jim Palenscar
From:
Oceanside, Calif, USA
|
Posted 24 Mar 2019 7:04 am
|
|
| Jerry is correct |
|
|
|
Bobby D. Jones
From:
West Virginia, USA
|
Posted 25 Mar 2019 7:13 pm pull rod size.
|
|
| 7/64 (.109) And it is funny, Some 7/64 rods will full thread with a 5X40 die. Some it takes a 4X40 to get a full thread. If you are making the full rod with 90 degree bend. Drill a 7/64 hole in a plate of steel the depth of the L bend on end. Hammer the rod over for a sharp bend so the rod will not drag on another rod or bell crank. Made a few rods and learned this the hard way. |
|
|
|
