| Author |
Topic: nv 1000 |
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 21 Mar 2019 9:04 am |
|
how can you tell if the reverb tank is bad? i pulled the tank and pulled the short rca cable which goes to wthe output side touched the end and it made a noise.but when i plugged it back in and hit the tank i didnt hear the boing from the spring so i reversed the leads and hit the tank i heard the boing but no reverb at 10 any hhelp is appreciated.
_________________
Mike Bowles |
|
|
 |
Dale Foreman
From:
Crowley Louisiana, USA
|
Posted 21 Mar 2019 9:16 am Reverb tank NV 1000
|
|
Get you a Mod replacement tank. They work better than the original OEM. They are inexpensive as well.
Dale
_________________
Rittenberry Prestige(2) |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 21 Mar 2019 9:41 am nv 1000
|
|
thanks Dale but i dont know if its bad or another problem changed wiring harness no reverb
_________________
Mike Bowles |
|
|
|
Dale Foreman
From:
Crowley Louisiana, USA
|
Posted 21 Mar 2019 9:49 am Nv 1000
|
|
Pull the tank out of the bag and turn it over and look to see if any springs are broken. Let me see if I can find the part number. It's very easy to remove the tank .
Dale
_________________
Rittenberry Prestige(2) |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 21 Mar 2019 10:02 am nv 1000
|
|
thanks Dale i already pulled the tank couldnt find anything wrong.
_________________
Mike Bowles |
|
|
|
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 21 Mar 2019 8:32 pm
|
|
This is where an ohm-meter would help... you can check the two connections, one should be low ohms (like 10 to 100), that's the input... the other should be higher, on the order of several hundred ohms, that's the output.
Either one open circuit, your tank is bad.
Think of a reverb tank as a speaker connected to a microphone by a spring... basically what you got there.
_________________
Too much junk to list... always getting more. |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 22 Mar 2019 7:31 am nv 1000
|
|
thanks all i will check with a meter
_________________
Mike Bowles |
|
|
|
Ken Fox
From:
Nashville GA USA
|
Posted 22 Mar 2019 1:52 pm
|
|
It would appear the output side of the tank is open. Check to see if a wire is broken or disconnected at the Output RCA female connection on the tank. If not the tank needs to be replaced
The reverb return circuit of the amp is working as you got a noise when touching the cable |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 22 Mar 2019 2:56 pm nv 1000
|
|
thanks ken i will probably replace the tank
_________________
Mike Bowles |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 23 Mar 2019 8:50 am Nv 1000
|
|
WHICH TANK TO REPLACE A 4EB2CIB? AND WHERE IS THE BEST PLACE TO GET ONE? THANKS IN ADVANCE
_________________
Mike Bowles |
|
|
|
Dale Foreman
From:
Crowley Louisiana, USA
|
Posted 24 Mar 2019 8:42 am Reverb
|
|
Ken Fox may know what the problem is. I forgot which chip Is for the reverb. I have a 3 spring Mod brand tank I could send to try out.
Dale
_________________
Rittenberry Prestige(2) |
|
|
|
Ken Fox
From:
Nashville GA USA
|
Posted 24 Mar 2019 9:06 am
|
|
 |
|
|
|
Ken Fox
From:
Nashville GA USA
|
Posted 24 Mar 2019 9:07 am
|
|
| The same tank is used in the N1000 amp. |
|
|
|
Ken Fox
From:
Nashville GA USA
|
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 24 Mar 2019 11:10 am nv 1000
|
|
thanks ken and all who helped thanks again
_________________
Mike Bowles |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 30 Mar 2019 12:41 pm reverb on nv1000
|
|
will a9EB2CIB THANK REPLACE THE TANK 4EB2CIB IN MY NV100? THANKS FOR ANY HELP.
_________________
Mike Bowles |
|
|
|
Ken Fox
From:
Nashville GA USA
|
Posted 31 Mar 2019 12:25 pm
|
|
| Yes it will work |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 1 Apr 2019 8:05 am Nv 1000
|
|
thanks ken for the help
_________________
Mike Bowles |
|
|
|
Mike Bowles
From:
Princeton, West Virginia, USA
|
Posted 5 Apr 2019 11:04 am nv 1000
|
|
just replaced the reverb tank in my 1000 no noise sounds good havent tried it much but so far so good thanks everyone for your help replaced it with a mod tank
_________________
Mike Bowles |
|
|
|
