| Author |
Topic: Emmons sd10 push pull questions |
Johnie King
From:
Tennessee, USA
|
Posted 25 Aug 2018 9:28 am |
|
Is this a double 10 conversion or did they make them with all the extra holes in end plate for production reasons. I’m thinking it’s been converted from a double 10 Thanks in advance
  |
|
|
 |
Jack Hanson
From:
San Luis Valley, USA
|
Posted 25 Aug 2018 1:42 pm
|
|
| You can't really tell from how the endplate is drilled, because the factory made loafers both ways. Some were drilled for the top neck only, and others were drilled for both. |
|
|
|
Ian Worley
From:
Sacramento, CA
|
Posted 25 Aug 2018 7:52 pm
|
|
| if the serial number has "ST" it's a factory loafer, if it has a "D" it's a converted D10 |
|
|
|
Dale Hampton
From:
Missouri, USA
|
Posted 25 Aug 2018 9:02 pm
|
|
I have one that is stamped "ST" and was never routed out for the C6 changer. If yours isn't routed for a changer on the back neck, it couldn't have been a D10 unless it has been plugged an re flocked. And, unless it has had the mica replaced, you could remove the pad to see.
 |
|
|
|
Johnie King
From:
Tennessee, USA
|
Posted 26 Aug 2018 7:17 am
|
|
| Thanks Dale yours sure looks good underneath. I like the sd10 better than s10 but would do away with pad or make a very thin flat pad. I would think one like yours would be worth much more than a S10 pp they are probably pretty rare. |
|
|
|
Johnie King
From:
Tennessee, USA
|
Posted 26 Aug 2018 7:23 am
|
|
| Ian thanks for info also. |
|
|
|
Johnie King
From:
Tennessee, USA
|
Posted 26 Aug 2018 7:29 am
|
|
| I wonder if the end plate casting were intentionality casted with the holes in them an drilled an sized after casting? |
|
|
|
Mike May
From:
North Carolina, USA
|
Posted 29 Aug 2018 3:08 pm P/p
|
|
| Hey Johnie. would have made a better picture if you took them ugly house shoes off....LOL |
|
|
|
Johnie King
From:
Tennessee, USA
|
Posted 29 Aug 2018 4:01 pm
|
|
Yes Mike I should have had my Sunday shoes on.
Next time I will paint my toenails just for you.
Last edited by Johnie King on 29 Aug 2018 5:21 pm; edited 1 time in total |
|
|
|
Steve Schmidt
From:
Ramsey, MN, USA
|
Posted 29 Aug 2018 7:14 pm
|
|
| I have an sd10 that was shipped from the factory with a D in front of the number. I have the factory invoice. It has a cutout for a C6th pickup. |
|
|
|
