| Author |
Topic: Peavey Classic 30 question |
Rich Upright
From:
Florida, USA
|
Posted 5 Jun 2018 7:52 pm |
|
When I turn on the reverb of my Classic 30, it works OK for a minute or 2 then starts a low,feedback type hum that gets louder until it is unusable. Lowering the bass EQ & reverb level below 3 seems to help, but then there really isn't any reverb left. Anyone have any ideas?
_________________
A couple D-10s,some vintage guitars & amps, & lotsa junk in the gig bag. |
|
|
 |
Stu Schulman
From:
Ulster Park New Yawk (deceased)
|
Posted 6 Jun 2018 5:46 am
|
|
Rich,I had a 30 and it stopped working in the middle of a song,everything was still lit up pilot,tubes but it just stopped making sounds?I was living in Anchorage and I took it to the only guy who would work on tube amps,I finally sold it,when it worked it sounded great,I had to sell it.
_________________
Steeltronics Z-pickup,Desert Rose S-10 4+5,Desert Rose Keyless S-10 3+5... Mullen G2 S-10 3+5,Telonics 206 pickups,Telonics volume pedal.,Blanton SD -10,Emmons GS_10...Zirctone bar,Bill Groner Bar...any amp that isn't broken.Steel Seat.Com seats...Licking paint chips off of Chinese Toys since 1952. |
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 6 Jun 2018 1:42 pm Peavey Classic 30
|
|
Call me toll free at 1-877-732-8391, ext.1180 Mon-Fri between the hours of 8am and 5pm CST. I have several suggestions that might work to eliminate this problem.
Mike Brown
Peavey USA |
|
|
|
Tim Whitlock
From:
Colorado, USA
|
Posted 7 Jun 2018 9:54 am
|
|
| Mike Brown to the rescue once again. You can't ask for better customer service! |
|
|
|
