| Author |
Topic: Changing copedents |
Zena Kay
From:
Los Angeles, CA
|
Posted 31 May 2018 9:04 pm |
|
| Hey y’all, just wanted to see if anyone can recommend anyone who has some good, detailed and accurate info on changing around copedents! I don’t feel comfortable doing it myself yet, and could use a book, writing, YouTube video? Anything! Ok thanks folks |
|
|
 |
Tim Herman
From:
Alberta, Canada
|
Posted 1 Jun 2018 3:59 am
|
|
| Mickey Adams has a dvd. |
|
|
|
Ian Rae
From:
Redditch, England
|
Posted 1 Jun 2018 8:38 am
|
|
A lot depends on what make of guitar you have, what skills/tools, and what kind of changes you propose. Perhaps you could tell us more.
_________________
Make sleeping dogs tell the truth!
Homebuilt keyless U12 7x5, Excel keyless U12 8x8, Williams keyless U12 7x8, Telonics rack and 15" cabs |
|
|
|
Charlie McDonald
From:
out of the blue
|
Posted 1 Jun 2018 9:51 am
|
|
| Would Clem Schmidt's book be appropriate? |
|
|
|
Dan Kelly
From:
Boston, MA
|
Posted 1 Jun 2018 11:58 am
|
|
Hey Charlie: I think Clem primarily addresses Emmons push pull set ups. I have his info around here somewhere.
Zena, what did you end up with?
_________________
blah, blah, blah.
Hey You Kids! Get Off My Lawn!
blah, blah, blah. |
|
|
|
Bobby D. Jones
From:
West Virginia, USA
|
Posted 9 Jun 2018 8:34 pm changing copendents
|
|
Before you start this project. I suggest you go through both copendents and see if you will have enough Bell Cranks, Rods, Cross rods and such. Check the rods and make sure you have enough rods long enough to do all the pulls.
It would be bad to get it partly changed and then have to start making rods or order them and lose a lot of time with the guitar in the middle of the changeover. Good Luck in this project. |
|
|
|
Jim Hussey
From:
Reno, Nevada - USA
|
Posted 10 Jun 2018 12:25 am
|
|
If you are working on a push pull, don’t do it. Take it to someone with p/p experience
If you are working on an all pull guitar, at a minimum, I would suggest these 2 steps:
1 – Make a rodding chart of your existing setup.
https://www.steelguitar.com/rodding.html
https://www.steelguitar.com/roddingS10_D10.html
You might try a search on the forum as rodding charts have been posted for most all pull makes.
2 – Get the Mickey Adams Video and follow it.
https://bb.steelguitarforum.com/viewtopic.php?t=261698&postdays=0&postorder=asc&highlight=video&start=75
The key to such a project is timing the changes. This is the reason for making a rodding chart of your existing setup. Assuming your guitar is properly timed now, you will want to know the current bell crank and raise / lower finger settings for each string. In addition to timing pedals and levers, you may have half stops and splits. If you have these, your rod chard will record them as well.
Another reason for the rodding chart is to know which strings (if any) have compensators. You may want that info before you take everything out.
On top of everything above, setting pedal stops is an important and often overlooked step. Mickeys video explains all this in minute detail. |
|
|
|
