HELP ON 8TH STRING LOWER E TO Eb

Paul Wade · From: mundelein,ill

HELP,
I WAS PLAING LAST NITE IN A CLUB AND HAD TROBLE WITH MY 8TH STRING LOWER E TO Eb
it would come back sharp then i have to retune every song. put a new string on ,still the same problem?? it's on my e9th neck it my older msa d-10 vintage xl. any help on this would be welcome.

paul wade
mundelein,ill

Larry Bell · From: Englewood, Florida

One thing to check on the older MSA's with the round cross shafts is that the bellcrank is not slipping on the shaft. Check the set screw.

There are a bunch of other things it could be, but try that first. If you're convinced it is tight, next thing is to make sure you have enough throw on the lever.

Try that and c'mon back with the results.

------------------
Larry Bell - email: larry@larrybell.org - gigs - Home Page
2003 Fessenden S/D-12 8x8, 1969 Emmons S/D-12 6x6, 1984 Sho-Bud S/D-12 7x6, 1971 Dobro, Standel and Peavey Amps

Tony Prior · From: Charlotte NC

not sure if this is applicable to your MSA but on my Sho-Bud..Pro III , I had a very similar issue and it was a worn finger rivet.

I took the changer assy apart and swapped fingers with a string finger that had no rods...

good as new..

good luck

t

[This message was edited by Tony Prior on 31 July 2005 at 08:51 AM.]

Donny Hinson · From: Glen Burnie, Md. U.S.A.

Most likely, the roller at the keyhead is not turning freely. Oil the roller, and make sure the string is pulling in a straight line (not pulling sideways) at the nut.

Paul Wade · From: mundelein,ill

thanks guy's for all your help. i am going to look at the guitar tonight i will give all of you a update

paul wade

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: