| Author |
Topic: Standel Imperial Schematics??? |
Pete Burak
From:
Portland, OR USA
|
Posted 16 Jul 2016 8:43 am |
|
I am looking for a Schematic for this Standel Imperial amp.
This one has one pre-amp tube, and two output tubes, as well as the epoxied module.
Amp works but has an ~120hz hum.
Are there any vintage Standel-electronics experts here in the US?
 |
|
|
 |
Mel Bergman
From:
Camarillo, California, USA
|
Posted 16 Jul 2016 10:19 pm
|
|
| Ol' Ed Sanner in Bakersfield is a Standel whiz. He resurrected my old Artist XII....PM me if you want his contact info. |
|
|
|
Pete Burak
From:
Portland, OR USA
|
Posted 17 Jul 2016 6:23 am
|
|
| PM Sent! |
|
|
|
Tim Whitlock
From:
Colorado, USA
|
|
|
|
Pete Burak
From:
Portland, OR USA
|
Posted 17 Jul 2016 10:23 am
|
|
| Yo! |
|
|
|
Michael Brebes
From:
Northridge CA
|
Posted 18 Jul 2016 6:48 am
|
|
I do repairs on the Standel amps as well. The Imperial hybrids are unique because the module schematics do not match those of the later solid state units, which are on the Standel website. The only schematic you will find is the the power supply listed as S100V. It uses the transistor potted modules for the preamp sections, then feeds the phase inverter tube which drives the two power tubes, which are either 6GW6's with the wire cap or 6GT7's. I am in the Los Angeles area, if you are in need of repairs.
_________________
Michael Brebes
Instrument/amp/ pickup repair
MSA D10 Classic/Rickenbacher B6/
Dickerson MOTS/Dobro D32 Hawaiian/
Goldtone Paul Beard Reso
Mesa Boogie Studio Pre/Hafler 3000
RP1/MPX100 |
|
|
|
