| Author |
Topic: Clutch parts for non pedal Fender legs |
Duane Becker
From:
Elk,Wa 99009 USA
|
Posted 30 Apr 2016 7:57 am |
|
I'm in need of the little round washer/spacers parts for steel guitar legs-to raise and lower the height, that I call clutch parts. I need them for three Fender non pedal legs.
Hope I'm clear with the names here. Anyone know of a person or place that I can buy?
Thanks |
|
|
 |
Jim Newberry
From:
Seattle, Upper Left America
|
Posted 30 Apr 2016 3:54 pm
|
|
Don at sales@bsgsteelguitars.com was able to help me. The replacement clutch parts work great.
_________________
"The Masher of Touch and Tone"
-1950 Fender Dual Pro 8
-1950's Fender Dual Pro 6
-Clinesmith D8
-Clinesmith 8-string Frypan
-Clinesmith Joaquin
-~1940 National New Yorker
-~1936 Rickenbacher B6
-Homebuilt Amps |
|
|
|
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 30 Apr 2016 7:11 pm
|
|
Make sure you check down inside the leg... sometimes they end up there. There should also be a brass ring to hold them together, a cone washer-thing.
_________________
Too much junk to list... always getting more. |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 30 Apr 2016 11:00 pm
|
|
I don't know if your Fender legs were made from Atlas mic stands, but a lot of steel guitar legs were.
If so, this company sells replacement parts for the Atlas stands. clickhere
I'm not a customer here or knowledgeable about the company, but they show replacement clutch parts.
Good luck with your repairs. |
|
|
|
Duane Becker
From:
Elk,Wa 99009 USA
|
Posted 1 May 2016 4:55 pm
|
|
| Thanks all for the info...Duane |
|
|
|
