| Author |
Topic: reverb cable for session 500 amp? |
Jack Goodson
From:
new brockton,alabama (deceased)
|
Posted 20 Oct 2015 7:47 am |
|
| i need the reverb cable for a session 500 (small chassic) amp. i need the parts to build a new one or if anyone has one they don,t need i would purchase it....thanks jack |
|
|
 |
Lane Gray
From:
Topeka, KS
|
Posted 20 Oct 2015 8:10 am
|
|
Have you checked with Peavey?
Is yours bad, or missing? It's got a Molex connector on the board end.
_________________
2 pedal steels, a lapStrat, and an 8-string Dobro (and 3 ukes)
More amps than guitars, and not many effects |
|
|
|
Jack Goodson
From:
new brockton,alabama (deceased)
|
Posted 20 Oct 2015 8:14 am cable
|
|
| lane, if i had the plug that plugs into the amp i could probably make one myself. i will check with peavey but they would probably have to make one which would cost more i'm sure. i also sent ken fox a message....thanks jack |
|
|
|
Jack Goodson
From:
new brockton,alabama (deceased)
|
Posted 20 Oct 2015 8:21 am cable
|
|
| just heard from ken, he doe's not do this type stuff anymore, so still looking....thanks jack |
|
|
|
Lane Gray
From:
Topeka, KS
|
Posted 20 Oct 2015 8:23 am
|
|
I'd take a picture of the connector and email electronics supply, see if they have them.
_________________
2 pedal steels, a lapStrat, and an 8-string Dobro (and 3 ukes)
More amps than guitars, and not many effects |
|
|
|
Lane Gray
From:
Topeka, KS
|
Posted 20 Oct 2015 8:31 am
|
|
I just called Electronics Supply in KC. They said you'd either have to bring the board in (there are 10,000 types of Molex connector).
I think if I felt up to making cables, I'd solder a cable onto the prongs on the board...
_________________
2 pedal steels, a lapStrat, and an 8-string Dobro (and 3 ukes)
More amps than guitars, and not many effects |
|
|
|
Bill A. Moore
From:
Silver City, New Mexico, USA
|
|
|
|
Jack Goodson
From:
new brockton,alabama (deceased)
|
Posted 21 Oct 2015 1:51 pm problem solved
|
|
| i found the female and male pins at radio shack, just installed the wires in them and used the old plastic part....thanks to everyone for the help....jack |
|
|
|
