| Author |
Topic: Want to buy Derby guitar parts. |
Robert Bowling
From:
Indiana, USA
|
Posted 4 Jul 2015 6:17 am |
|
I am wanting to ad a fourth floor pedal and vertical knee lever to a 3x4 set up sd-10 Derby.
At this time I'd be glad to get any parts I can to get started on the project.7/64 pull rods, cross rods, bell cranks, floor pedal. I have the vertical lever but I need the stop. Thank you |
|
|
 |
John Peay
From:
Cumming, Georgia USA
|
Posted 4 Jul 2015 10:49 am Derby Parts...
|
|
Email Bob Calloway at Calldrbybob@aol.com
He worked for Derby, and I've purchased parts from him before... |
|
|
|
Robert Bowling
From:
Indiana, USA
|
Posted 5 Jul 2015 5:24 am derby parts
|
|
John,
I have talked to Bob. He is not real active due to the heat and humidity we have been getting lately. So I thought I'd check the forum.
Thanks |
|
|
|
Jerry Roller
From:
Van Buren, Arkansas USA
|
Posted 6 Jul 2015 10:18 pm
|
|
Robert, I have a few bellcranks and a couple of pedals. I may have a knee lever but I would need a photo of a lever like you need. I don't have a pedal cross shaft but may have one for the knee lever.
Jerry
rollermusic@cox.net
_________________
http://www.littleoprey.org/ |
|
|
|
Robert Bowling
From:
Indiana, USA
|
Posted 7 Jul 2015 1:03 am derby guitar parts
|
|
Jerry,
I emailed a picture of the pedals on the guitar
the bracket is 3/16 thick. I have found the pedal cross rod needed. So at this time I need some 7/64 threaded pull rods. A vertical knee lever stop bracket. A foot pedal. The knee lever cross rod. And some of the brass barrels that go in the bell cranks. Plus a few more nylon tuner nuts. Damir had a red derby not to long ago that had some good underneath pic's of the vertical setup. Thanks a bunch for response. I will pm my phone number also. |
|
|
|
Robert Bowling
From:
Indiana, USA
|
Posted 10 Jul 2015 3:45 pm derby guitar parts
|
|
Jerry, I have sent a couple emails and pm's
Thanks Robert |
|
|
|
