| Visit Our Catalog at SteelGuitarShopper.com |

Post new topic Seeking Some Pointers for Recording into Garage Band
Reply to topic
Author Topic:  Seeking Some Pointers for Recording into Garage Band
Mark Hershey

 

From:
New York, USA
Post  Posted 25 Mar 2015 8:31 am    
Reply with quote

I have an Apogee one and I use a direct input with guitar through a Garageband amp to record my ideas.

Any pointers for best way to record pedal steel into Garageband mostly for just practice purposes. I really just want to record along with jam tracks and listen back to my playing.

Many thanks!
View user's profile Send private message Send e-mail
John Owen


From:
Seattle, Washington, USA
Post  Posted 25 Mar 2015 9:42 am    
Reply with quote

For practice purposes, I use basically the same approach as you describe for your guitar on PSG as well. It's actually easier for me to get a decent recorded sound going direct and using the software's amp simulator than trying to mic my amp when I am trying to keep it quite enough not to wake my family up. I just set the amp simulator for a cleaner sound than I would typically use for guitar. Other than that, pretty much the same deal.
_________________
Williams S-10, Beard R-model, Gibson BR-4 lap steel, Fender lap steel, Brownface Princeton, Goodsell Custom 33, 70's Tele Thinline, Fubar Twangmaster, Fubar Custom Buckarooster, Collings CJ Mh flattop
View user's profile Send private message Send e-mail Visit poster's website
Mark Hershey

 

From:
New York, USA
Post  Posted 25 Mar 2015 10:21 am    
Reply with quote

John Owen wrote:
For practice purposes, I use basically the same approach as you describe for your guitar on PSG as well. It's actually easier for me to get a decent recorded sound going direct and using the software's amp simulator than trying to mic my amp when I am trying to keep it quite enough not to wake my family up. I just set the amp simulator for a cleaner sound than I would typically use for guitar. Other than that, pretty much the same deal.


You have any suggestions for settings? I've tried tooling around and haven't been able to find a reasonable sound.

Perhaps its just a matter of tweaking the volume and master level until I find something I can live with.
View user's profile Send private message Send e-mail
John Owen


From:
Seattle, Washington, USA
Post  Posted 25 Mar 2015 3:07 pm    
Reply with quote

I don't recall exact settings at the moment. I have been using Logic Express instead of Garage Band for quite a while. Some of the plug-ins in Logic Express are from Garage Band and others are just in Logic. Not sure which are which off the top of my head.

I'll try to take a look when I get home. In general though, I tend to go with a pretty low setting on the volume/gain knob (around 2 or 3 on a scale of 10) and adjust the 'master' volume to taste. I also tend to roll back the treble to 3 or 4 and boost the mid and low a little. Obviously though, that stuff is totally up to personal taste. If it still sounds thin after messing with the eq settings, you might try a dash of light compression (comp ratio of 2:1 or lower). If you go that route, I'd suggest starting with one of the 'light compression' presets for vocals and adjusting from there. Don't tell the compressor police on SGF though.
View user's profile Send private message Send e-mail Visit poster's website
Mark Hershey

 

From:
New York, USA
Post  Posted 25 Mar 2015 5:14 pm    
Reply with quote

I apologize, I didn't realize there was a recording section on the forum...I started a different thread over there. Thanks for your response John, I will try that out.
View user's profile Send private message Send e-mail

All times are GMT - 8 Hours
Jump to:  
Please review our Forum Rules and Policies
Our Online Catalog
Strings, CDs, instruction, and steel guitar accessories
www.SteelGuitarShopper.com

The Steel Guitar Forum
148 S. Cloverdale Blvd.
Cloverdale, CA 95425 USA

Click Here to Send a Donation

Email SteelGuitarForum@gmail.com for technical support.


BIAB Styles
Ray Price Shuffles for Band-in-a-Box
by Jim Baron