Author |
Topic: p/p input plug wire |
Charlie Moore
From: Deville, Louisiana, USA
|
Posted 28 Jan 2004 7:43 pm
|
|
The hot wire from the input jack came loose,anybody know where it goes,can't see where it came from!!!Thanx.....
Charlie.... |
|
|
|
Jerry Roller
From: Van Buren, Arkansas USA
|
Posted 28 Jan 2004 7:47 pm
|
|
Charlie, which end of the wire came loose? Do you need to know where to solder it to the neck switch or the jack in the end plate?
Jerry |
|
|
|
Charlie Moore
From: Deville, Louisiana, USA
|
Posted 28 Jan 2004 7:52 pm
|
|
To the neck switch Jerry,.Charlie.... |
|
|
|
Jerry Roller
From: Van Buren, Arkansas USA
|
Posted 28 Jan 2004 7:56 pm
|
|
Charlie, it goes on the first lug toward the back neck on the end closest to the pickup. There are three lugs on the back of the switch and four lugs on the front of the switch. It goes on the first lug on back of the switch on the end closest to the pickup.
Actually it can go on just about any lug except the ones the positive leads from the pickups are on and not grounded.
[This message was edited by Jerry Roller on 28 January 2004 at 08:05 PM.] |
|
|
|
Charlie Moore
From: Deville, Louisiana, USA
|
Posted 28 Jan 2004 8:34 pm
|
|
Well Jerry,i tried it there back neck only works!!!!!!! ive got something wrong,.i changed the pick ups hooked up something wrong..ill go look at another one tomorrow,thanks Jerry...
Charlie..... |
|
|
|
Charlie Moore
From: Deville, Louisiana, USA
|
Posted 29 Jan 2004 2:47 pm
|
|
Thank's Jerry.....got it fixed,B0B you can close this,thank you for the forum,.
Charlie........ |
|
|
|