| Author |
Topic: NV400 / RP155 Question |
Richard Sinkler
From:
aka: Rusty Strings -- Missoula, Montana
|
Posted 16 Mar 2014 12:54 pm |
|
I have an RP155 that I use only for reverb and is set on top of my amp and I use the front effects loop. My question is, can I use longer cords from the effects loop to be able to set it on the floor so I can switch programs with my foot. My distortion unit (Damage Control Liquid Blues) all of sudden started cutting out all my highs. The reverb in my amp has a high pitched squeal, so I don't have the molex plug even plugged in. Would doing this affect the distortion patches?
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 55 years and still counting. |
|
|
 |
Mike Wheeler
From:
Delaware, Ohio, USA
|
Posted 16 Mar 2014 2:18 pm
|
|
I don't think you'll have any problem, Richard. As long as you're using good cables, your sound should be as good as with the short cables.
_________________
Best regards,
Mike |
|
|
|
Dustin Rigsby
From:
Parts Unknown, Ohio
|
Posted 16 Mar 2014 2:29 pm
|
|
Yep you can do that. I run mine in front of the pre amp and that sounds good too. Very quiet unit as well. I get no noise at all. I use George L's cables,but,any quality cable will be just fine. I hate the Peavey reverb...it's just too noisey.
_________________
D.S. Rigsby |
|
|
|
