| Author |
Topic: Emmons Pedal Rods Length?? |
Bob Bartoli
From:
Pennsylvania, USA
|
Posted 28 Sep 2013 1:32 pm |
|
| I have 8 Push /Pull pedal rods that measure 22 +7/8's , what are the various pedal rod lengths for the P/P guitars, these are too short for my guitar without the extenders on them.....Thanks |
|
|
 |
Tommy Auldridge
From:
Maryland, USA
|
Posted 29 Sep 2013 5:47 am ????
|
|
| You're welcome. |
|
|
|
Bob Bartoli
From:
Pennsylvania, USA
|
Posted 29 Sep 2013 6:29 am emmons
|
|
| TTT |
|
|
|
Bob Bartoli
From:
Pennsylvania, USA
|
Posted 29 Sep 2013 6:29 am emmons
|
|
| TTT |
|
|
|
Chris Lucker
From:
Los Angeles, California USA
|
Posted 29 Sep 2013 3:18 pm
|
|
You have a mid 1970s push pull.
The standard measurement from underside of the endplate (near the front leg socket) to the floor is 26 inches-- that is straight down to the floor, not parallel to the legs.
Your 3/16ths pedal rod would correspond to this 26 inch measurement by being 24 3/4" total or about 24 9/16ths from the inside of the hook to the tip of the 10:32 rolled threads.
The rolled thread length should be about 1.250".
The centerless ground hook length should be about an inch -- almost an inch.
The hook diameter probably should be 0.125 but I find 0.127 to 0.131".
The 0.375" dia hex hole is tapped 10:32 and the hexes are 1.750 inches long.
Earlier versions of pedal rods will be different because the hooks are different and pedal cranks are different and the connectors to the pedals are different etc.
Chris Lucker
_________________
Chris Lucker
Red Bellies, Bigsbys and a lot of other guitars. |
|
|
|
