Peavey 3-wire connection

Jim Saunders · From: Houston, Texas, U.S.A.

Anyone have a diagram of the Peavey recommended 3-wire connection? I know how to make the connection from VP to the pre-EQ and guitar to the input, but I need the deagram for a friend.

CrowBear Schmitt · From: Ariege, - PairO'knees, - France

Hope this is it
http://www.peavey.com/media/pdf/steelguitar/pre_eqpatch.pdf

Jim Saunders · From: Houston, Texas, U.S.A.

Thanks, Crowbear. Yes, that's it, but if anyone has a simpler version, I'd appreciate that too. One with the volume pedal drawn in.

CrowBear Schmitt · From: Ariege, - PairO'knees, - France

Jim, what amp are you using ?
the set up is rather simple as long as you have the "loop Send / Return " Pre EQ Patch found on certain Peavey amps

Note that this hook up is for Passive VPs : Goodrich 120
Not Active ones : Hilton, Telonics

instrument goes direct to the main input (High Gain / Low Gain)
Volume pedal input is plugged into " Send "
Volume pedal output is plugged into " Return "

Jim Saunders · From: Houston, Texas, U.S.A.

Crowbear, I have a Nashville 112 and a Goodrich L120 pedal, so this schematic works. I was just looking for a more simple (dumb ass) version showing the VP in the diagram and the amp face plate. Thanks.

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: