Rack case customized for pedal steel

Don Hinkle · From: Springfield Illinois, USA

I bought this case new about 18 months ago or so and modified it in the following way;

* - Installed Furman PL-8 with 2 pull out lights with dimmer
- Wired the electrical outlet on the Furman to the 3 prong flush mounted
electrical connector that is installed in the polished plate. (allows you to plug in a standard computer cable to
power the entire rack)

* - Standard AC power outlet (I used it to power my NV400 and such)
- Outlet is wired to a protected outlet on the Furman PL-8

* - 110V fan mounted into the rack case.
- plugged into a protected outlet on the Furman PL-8

* - 2 output jacks (1/4" push n lock) mounted in the same plate that the power
input jack is mounted in.
- The jacks are wired to 2 1/4" plugs inside the rack. I have them plugged into
the 2 outputs on the transtubefex or the tubefex. If playing only one amp, I
would plug mono out of each of the 2 processors to switch and compare.

This is a NICE case.
It is as simple as plugging the power cable into the case, plugging your guitar cables to the 1/4" jacks, take off the top and you are ready to roll!!! Take your pick, its either a lazy or smart mans setup Winking

Asking 350 for it with the Furman installed.

At this price, I will be taking out the tuner and both effects processors.
I am going to list the efx unites in separate listings.

_________________
Emmons Legrande III SD10
Emmons Legrande III D10
Session 400
Fender guitars
Fender amps

Don Hinkle · From: Springfield Illinois, USA

ttt
_________________
Emmons Legrande III SD10
Emmons Legrande III D10
Session 400
Fender guitars
Fender amps

Don Hinkle · From: Springfield Illinois, USA

ttt
_________________
Emmons Legrande III SD10
Emmons Legrande III D10
Session 400
Fender guitars
Fender amps

Forum Index > For Sale: Amps and Accessories		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: