| Author |
Topic: Sierra S8 lap steel pickup install |
Dwight Lewis
From:
Huntsville, Alabama
|
Posted 14 Jun 2012 12:52 pm |
|
I have a Sierra s8 with volume tone knobs, I am trying to install a George L 10-5 pickup. I want to keep my volume and tone knobs,. Any ideas or drawings on how I need to wire this baby up?
Dwight
ijaash@yahoo.com
_________________
Dekley 7p4k(PRS-10C), BMI S12 5p5kn |
|
|
 |
Steve Humes
From:
Tampa, Florida, USA
|
|
|
|
Lane Gray
From:
Topeka, KS
|
Posted 14 Jun 2012 2:41 pm
|
|
I didn't poke around too extensively at that site, so I suppose there mighta been an answer for that setup buried in the humbucker section.
I would put the volume and tone circuit between the 5-way switch and the output jack.
_________________
2 pedal steels, a lapStrat, and an 8-string Dobro (and 3 ukes)
More amps than guitars, and not many effects |
|
|
|
Bob Tuttle
From:
Republic, MO 65738
|
Posted 14 Jun 2012 6:27 pm
|
|
 |
|
|
|
Lane Gray
From:
Topeka, KS
|
Posted 14 Jun 2012 6:35 pm
|
|
Switch position 6 reminds me:
Why did the chicken cross the Möbius strip?
To get to the same side.
_________________
2 pedal steels, a lapStrat, and an 8-string Dobro (and 3 ukes)
More amps than guitars, and not many effects |
|
|
|
Dwight Lewis
From:
Huntsville, Alabama
|
Posted 15 Jun 2012 9:03 am Sierra S8 pickup wiring
|
|
Thanks a lot members, I think this website will do the trick."
Dwight
_________________
Dekley 7p4k(PRS-10C), BMI S12 5p5kn |
|
|
|
