| Author |
Topic: Transtubefex (with problem) Sold, please close. |
Jerry Roller
From:
Van Buren, Arkansas USA
|
Posted 17 Dec 2010 1:29 pm |
|
I have what was a very nice Transtubefex. I purchased a batteryless chip for it and in process of prying the old chip out, I stupidly put the screwdriver between the chip holder and printed circuit board and damaged the printed circuit. I managed to patch the circuit with solder and fine wire and thought it was working fine. A friend used it with his rack and told me one channel was not working and sure enough, it is not. One channel works fine but nothing out of the other. I know nothing about electronics so perhaps someone who is good with this sort of thing can fix it or might need parts. I would like to sell it for $85.00 shipped so I can apply that to purchasing another on. The batteryless chip has since been used in a Profex II and is not included.
Jerry
Last edited by Jerry Roller on 19 Dec 2010 10:56 am; edited 1 time in total |
|
|
 |
Mike Wheeler
From:
Delaware, Ohio, USA
|
Posted 18 Dec 2010 8:17 am
|
|
Jerry, if you can take Paypal, I'll take a chance on it and buy it.
Please send me your email address for payment.
_________________
Best regards,
Mike |
|
|
|
Jerry Roller
From:
Van Buren, Arkansas USA
|
Posted 18 Dec 2010 10:28 am
|
|
Mike, I have emailed you via of Forum email.
Jerry |
|
|
|
Mike Wheeler
From:
Delaware, Ohio, USA
|
Posted 18 Dec 2010 2:40 pm
|
|
Email received and payment sent, Jerry.
Thanks.
_________________
Best regards,
Mike |
|
|
|
Jerry Roller
From:
Van Buren, Arkansas USA
|
Posted 19 Dec 2010 10:55 am Sold. Please Close
|
|
Thanks Mike. OK to close.
Jerry |
|
|
|
