| Author |
Topic: 7/8 X 3+3/8 WHITE ZIRC material ordered |
ed packard
From:
Show Low AZ
|
Posted 24 Jul 2010 7:00 am |
|
| The vote on 7/8" White Zirc Bars indicates that 3+3/8" is the length to go with. The material has been ordered...now the long wait. Send me an email to get on the list. |
|
|
 |
Jerry Lee Newberry
From:
Prim, AR USA
|
Posted 26 Jul 2010 12:28 pm
|
|
I have a list that I sent in a long time ago. Hope the ones on my list get a bar. They have been on it a LONG TIME!!!!!!!!
Donna |
|
|
|
ed packard
From:
Show Low AZ
|
Posted 26 Jul 2010 1:21 pm Once upon a time
|
|
Sorry Donna...I have no way of knowing. That list was between them, you, and Leo. Leo is not involved here. I got back into the Zirc thing because of the "LONG TIME" and other negative aspects involved that I got email about after I left it in Leo's hands.
I would hope that it was material problems.
Edp |
|
|
|
Dick Shive
From:
Wood River, Illinois, USA
|
Posted 1 Aug 2010 5:22 pm white Zirc
|
|
Would someone please tell me what this mat'l for bars is, and is it a good as stainless? Dick, the steeler
_________________
Dick The Steeler |
|
|
|
ed packard
From:
Show Low AZ
|
Posted 1 Aug 2010 5:39 pm Material is
|
|
ZIRCONIUM DIOXIDE = ZIRCONIA = ZrO2.
Translation...a hi-tek ceramic. starts as a mix of very fine powder, is packed at high pressure and high heat to get "near form". Diamond wheels are used to machine it to final form; then optical polishing techniques using sub micron diamond slurry are applied to get the final finish.
The serial numbers are laser engraved.
The density is 0.77 times that of tool steel. The hardness is near that of tool steel.
There are many types of stainless steel. Zirc is lighter, and nearly as hard...perhaps harder than some types.
Zirc does not oxidize.
Zirc is used in many hi-tek, and medical applications such as hip joints. |
|
|
|
Dick Shive
From:
Wood River, Illinois, USA
|
Posted 6 Aug 2010 3:17 pm the 7/8 X 3 3/38 XR02 for steel guitar bars
|
|
I just happened to read your posts about this stuff and have seen pictures of people using them but didn't know what they were. Is any one ordering any of these bars or the material or where is it obtainable? Thanks dick
_________________
Dick The Steeler |
|
|
|
ed packard
From:
Show Low AZ
|
Posted 6 Aug 2010 3:27 pm Where to get ZIRC bars
|
|
Dick;
An Email to Vinh at zirbar@gmail.com will get you info and or the bars.
Edp |
|
|
|
Jerry Lee Newberry
From:
Prim, AR USA
|
Posted 7 Aug 2010 8:56 am
|
|
I have been talking to Vinh since he took over the bars. I sent him my list of names so I am hoping he uses it.
Donna |
|
|
|
