| Author |
Topic: Hilton pedal not staying in the off position |
Richard Sinkler
From:
aka: Rusty Strings -- Missoula, Montana
|
Posted 1 Aug 2010 11:29 am |
|
I have a Hilton low profile pedal and when I take my foot off the pedal, it does not stay in the full off position. It creeps down a bit. I noticed the the bolts on the sides of the pedal were loose and could be turned by hand. I tightened the up a little and no change. Is there another place to make this adjustment.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 54 years and still counting. |
|
|
 |
Bo Borland
From:
South Jersey -
|
Posted 1 Aug 2010 12:22 pm
|
|
Richard,I would suggest you check the Hilton manual Keith supplies.
There is a tension spring that can be adjusted.. I will scan the page and post it here .. Bo
Hope this solves the problem |
|
|
|
Richard Sinkler
From:
aka: Rusty Strings -- Missoula, Montana
|
Posted 2 Aug 2010 12:17 pm
|
|
Thanks Bo. I couldn't find my manual (dang thing keeps moving to a different hiding place). I knew there was an adjustment, but couldn't remember where. I'll give it a shot.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 54 years and still counting. |
|
|
|
