| Author |
Topic: Liftkit for D-10, 1 inch |
Randy Brown
From:
Knoxville, Tennessee, USA
|
Posted 18 Aug 2006 3:50 pm |
|
| Looking for a 1 inch lift kit for a D-10, with 8 pedal rod extenders. Thanks! |
|
|
 |
Jim Bob Sedgwick
From:
Clinton, Missouri USA
|
Posted 19 Aug 2006 7:13 pm
|
|
| Bobbe Seymore has them in his shop. |
|
|
|
Randy Brown
From:
Knoxville, Tennessee, USA
|
Posted 20 Aug 2006 5:04 am
|
|
Thanks Jim Bob. I saw them on Bobbe's website, and I may wind up getting it from him... I thought I would put this out there to save a few bucks if possible.
By the way, it is for a '99 Carter D10. |
|
|
|
Ernie Pollock
From:
Mt Savage, Md USA
|
Posted 20 Aug 2006 12:53 pm
|
|
Just got to your local hardware store or Lowes, they have those little drawers full of things that you can screw your pedal rod into, then get a some small [usually black] machine screws that you use the allen wrench with, they have no head, screw one into one end, your rod on the other, get a hand full of nuts to fit, & you can raise your steel up. Of course you'll need a piece of dow pin to cut & put in the front legs to hold them up. You can can do this with just a couple of bucks & save your $$$ for new strings!! If you can't find any let me know.
Ernie  http://www.hereintown.net/~shobud75/stock.htm
------------------
|
|
|
|
Roger Pearson
From:
Fort Dodge, Iowa USA
|
Posted 21 Aug 2006 5:12 am
|
|
| I have a set of extenders I got when I bought my D-10 Emmons a few years ago. I will sell them cheap if I can locate them. I am on the road until next weekend. If I can find them when I get home, I'll email you. Do you know if Emmons extenders will fit your guitar? [This message was edited by Roger Pearson on 21 August 2006 at 06:14 AM.] |
|
|
|
Ernie Pollock
From:
Mt Savage, Md USA
|
|
|
|
Randy Brown
From:
Knoxville, Tennessee, USA
|
Posted 24 Aug 2006 3:34 am
|
|
Thanks guys. Ernie, I will take a look at lowes next time I'm by there, but I'm still curious where to get the spacers for the front legs (or if I really need them).
Roger, It looks like the thread is about 3/16 of an inch (not sure if I measured it correctly though). I would be interested in your lift kit if you can find it.
Thanks! |
|
|
|
Ernie Pollock
From:
Mt Savage, Md USA
|
Posted 24 Aug 2006 3:59 am
|
|
Randy: ; just get a piece of dowl pin [wood]
that will fit inside the front leg make them about 1" long, slide em in the front leg, that will take care of the spacers.
Ernie Pollock
------------------
|
|
|
|
