Emmons P/P Neck

Lynn Stafford · From: Ridgefield, WA USA

I want to replace an improperly machined neck on a Emmons Push-Pull Reissue D10 I recently acquired. As you can see in the photo, too much material was removed from the pickup relief on the front neck. The adjustment screw hole has broken through! I would like to find a good match to the correct one on the back neck.

Hopefully someone out there has one they would be willing to part with. Perhaps after a D10 to SD10 conversion.

Thanks,
Lynn

Willard Wheeler · From: Illinois, USA

lynn check your email... here is a possible solution for you to consider....regards...lee

Lynn Stafford · From: Ridgefield, WA USA

Lee,

I didn't receive any email from you. Please re-send it.

Thanks,

Lynn

Lynn Stafford · From: Ridgefield, WA USA

Thanks for your suggestion, Lee. I'm not going to do any modifications at this point though. I'm still hoping someone might have an extra neck laying around that they'd like to sell.

Lynn

Forum Index > Wanted To Buy		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: